Lite Coat - Masonry
Direct Applied Rendering Cladding System for Concrete & Masonry
Description

Lite Coat is a non-insulated non-combustible direct applied wall coating system. The system consists of one or two base coats, (depending on substrate deviation rectification required), The finish texture coat can be selected from any one of the available Durex® Architectural Coatings. The system is typically not reinforced but as an option the scratch coat can be reinforced with synthetic fibers. 

Advantages
  • Economical
  • Easy to install
  • Non-combustible
  • High impact resistance
  • Excellent for both new and retrofit work
Uses

Lite Coat is an excellent cost effective coating system for both new and restoration work. It can all be used as a parging system, best suited for concrete, masonry or solid & clean old plaster substrates.

Performance Properties
Building Code Conformance

Classification

Category 2

Non-Combustible Stucco cladding System

Part 3

  • Article 3.1.5.2
  • Article 3.2.3.7 & Table 3.2.3.7
  • Allowable Minor Combustible Components
  • 0-10% Unprotected Openings

Part 5

Section 5.6.1

Protection from Precipitation

Part 9

Section 9.27.2

Required Protection from Precipitation

SUBSTRATE:

Masonry

New or existing masonry

must be clean & sound (refer to system specifications for further details

WATER RESISTIVE BARRIER:

Not applicable

Durex Lite Coat MASONRY imparts water repellant properties

REINFORCEMENT:

Not applicable

Additional reinforcement can be achieved by adding synthetic

fibers to the scratch coat

BASE COAT:
  • Durex Uniplast / Acrylic Resin Bond
  • Durex Dryplast
  •  CAN/ULC S114
  • CAN/ULC S114
  • Rated noncombustible
  • Rated noncombustible
FINISHES:

Durex Architectural  Coatings

   Classic Series

   Premium Series

   Artisan Series

   Kolor Gard Series

   Elastomeric (FX) Series

CAN/ULC S716.1   &

CCMC Report #  13103-R

(Refer to product specific Technical

Data Sheet and CCMC Evaluation

Report # 13103-R for more detailed data)

Durex Architectural Coatings

Meet and exceed all requirements

PERFORMANCE:

Shear Bond Adhesion

ASTM C882

11.20 MPa (1625 psi)

Water absorption

ASTM D570

1.9%   (Uniplast)

Coefficient of Water Absorption

CCMC 5.5.1

0.0007 kg/(m2.s1/2) (Flecrete)

Tensile Strength

ASTM C190

6.00 MPa (870 psi)

System Layer Optional Products Per Layer Notes
Base Coat
 
 
Primers
 
Finishes - Classic Series
 
 
 
 
 
 
 
 
 
Finishes - Premium Series
 
 
 
 
 
 
Finishes - Artisan Series
 
 
 
 
 
 
 
 
Finishes - Flexible Series
 
 
 
 
 
 
Finishes - Kolor Gard
 
 
 
 
 
 
 
Galvanized Trim