7 m²/L (300 ft²/gal) @ 5 mils DFT
Epoxane Marine-Grade Exterior Metal & Concrete Protective Coating is a two-component, epoxy-hybrid coating specially formulated to perform in off-shore salt water environments. It is strongly recommended where superior UV, weathering and corrosion resistance are demanded.
- Corrosion resistant; designed specifically for demanding offshore marine applications.
- High-tear resistance and tensile strength.
- Excellent adhesion to metal, steel and aluminum.
- Abrasion resistant and UV resistant.
- Very low VOC.
- Isocyanine free.
- Resistant to moisture.
- Outstanding gloss retention.
Epoxane Marine-Grade Exterior Metal & Concrete Protective Coating is used as a corrosion-resistant coating for marine and salt water environments. It is also an excellent protective floor and wall coating for chemical plants. Epoxane Marine-Grade Exterior Metal & Concrete Protective Coating is used to protect a variety of surfaces, namely steel, non-ferrous metals and concrete.
Colour | Please see Durex® Colour Selection Guide for available colour options. | |
Resin Type | Epoxy hybrid | |
Coverage | 7 m²/L (300 ft²/gal) @ 5 mils DFT | |
Recommended Film Thickness | 5-8 mils | |
Cure Time @ 23°C (75°F), 55% RH |
| |
Mix Ratio Part A (Resin):Part B (Catalyst) | 7:1 by volume | |
Pot Life @ 23°C (75°F) | 6 hours | |
Reducer/Clean-Up | Lacquer thinner or IPA |
Method | Results | |
---|---|---|
Percent Solids | ASTM D7232 | 90% (vol.) |
Viscosity (Brookfield) 23°C (75°F) | ASTM D2196 | 60-75 KU |
V.O.C. | ASTM D3960 | < 40 g/L |
Specific Gravity | ASTM D333 |
|
Compressive Strength | ASTM 695 | 10,370 psi |
Tensile Strength | ASTM 695 | 3,500 psi |
Tensile Modulus | ASTM 638 | 145 psi |
Elongation | ASTM D638 | 20% |
Flexural Modulus | ASTM D790 | 383 psi |
Abrasion Resistance | ASTM D4060 | 35 mg |
Mar Resistance | ASTM D5178 | 1.0 kg |
Water Immersion, 38 c, 500 Hr. | ASTM D870 | Pass, no blister; 200 microns DFT |
QUV Weathering, Gloss Retention | ASTM D4587 | 300 Hr. initial; 90% final, 41% no Chalking-colour retention (delta) 3.8 |