7 m²/L (400 ft²/gal) @ 2 mils DFT
Epotel WB DTM Water-Based Epoxy Corrosion-Resistant Direct-to-Metal Coating is a two-component, very versatile, water-based high-performance metal coating.
- Water based.
- Zero to low VOCs and odour free.
- Excellent adhesion to metal and a wide variety of substrates.
- Non-flammable.
- Outstanding water pounding and chemical resistance.
- Good leveling, flow and microform-free properties.
- Good anti-corrosion properties.
Epotel WB DTM Water-Based Epoxy Corrosion-Resistant Direct-to-Metal Coating can be used over a variety of metal surfaces to prevent the corrosion of steel and various metals. In exterior applications, Epotel WB DTM Water-Based Epoxy Corrosion-Resistant Direct-to-Metal Coating must be coated with Aquathane Pigmented Water-Based Acrylic/Urethane Coating for UV stability.
| Colour | Please see Durex® Colour Selection Guide for available colour options. | |
| Resin Type | Water-based Epoxy | |
| Coverage | 7 m²/L (400 ft²/gal) @ 2 mils DFT | |
| Cure Time @ 23°C (75°F), 55% RH |
| |
| Mix Ratio Part A (Resin):Part B (Catalyst) | 1:3 by volume | |
| Pot Life | < 3 hours | |
| pH Level | 9-10 | |
| Reducer/Clean-Up | Water |
| Method | Results | |
|---|---|---|
| Percent Solids | ASTM D7232 | 70 ± 2% (vol.) |
| Viscosity (Brookfield) 23°C (75°F) | ASTM D2196 | 2,000 cps |
| V.O.C. | ASTM D3960 | < 20 g/L |
| Specific Gravity | ASTM D333 |
|
| Flow Out (cm) | 15.00 (50 x 24 mm disc; 2 min flow out) |
