7 m²/L (260 ft²/gal) @ 3 mils DFT per coat
Epoxy Guard Pro Water-Based Epoxy Coating is a two-component, versatile, professional-grade UV-resistant water-based epoxy coating for floor and wall applications over concrete, gypsum and steel surfaces.
- Excellent UV resistance over standard epoxy coatings
- Water-based, very low VOC and virtually odourless
- Self-priming, fast drying
- Excellent adhesion to wide variety of substrates
- Very low flame spread rating
- Excellent abrasion resistance
- Outstanding water pounding and chemical resistance
- Excellent leveling, flow and microform-free properties
- No induction time
- CFIA approved, USDA accepted
Epoxy Guard Pro is a versatile, hard-wearing protective coating for walls and floors typically used as a protective interior wall coating for concrete and drywall in high-traffic applications exposed to UV rays or that require a non-yellowing finish. Mainly for use in institutional and industrial applications. It is also an excellent protective coating for metal surfaces.
| Colour |
| |
| Resin Type | Water-based epoxy | |
| Coverage |
| |
| Mix Ratio |
| |
| Cure Time @ 23°C (75°F) |
| |
| Pot Life - working time @ 23°C (75°F) | 2-3 hours | |
| Reducer/Clean-Up | Water | |
| V.O.C. | < 30 g/L | |
| pH Level | 7-8 |
| Method | Results | |
|---|---|---|
| Percent Solids | ASTM D7232 | 50 ± 2% (vol.) clear |
| Viscosity (Brookfield) 23°C (75°F) | ASTM D2196 | 500-800 cps |
| Specific Gravity | ASTM D333 |
|
| Flow Out (cm) | 15.00 (50 mm x 25 mm Disc-2 min flow out) | |
| Abrasion Resistance | ASTM 5178 | 100 mg/1000 cycles |
| Hardness (Pencil) | ASTM D3363 | F-HB |
| Water Vapour Transmission | ASTM E96 | 6.67 US Perms |
