Durex® Uraflex 150SC Flexible Industrial Floor Coating is a 100% solids, two-component polyurethane protective industrial floor coating with a smooth, slightly orange-peel finish. It is specially formulated to perform where low temperature, flexibility, abrasion and chemical resistance are required. This product has excellent chemical properties which make it an extremely versatile coating that outperforms standard epoxy coatings in regards to flexibility and abrasion resistance.
- Excellent adhesion to a variety of substrates
- Outstanding stability at low temperatures
- Excellent moisture resistance
- Bonds to metal
- Smooth, slight orange peel finish
- Extremely Abrasion resistant
- Penetrates and seals the surface
- Can be applied on walls > 250 microns thickness
- Canadian Food Inspection Agency approved, USDA accepted
Durex® Uraflex 150SC Flexible Industrial Floor Coating is used in a variety of interior protective floor-coating applications. To be used where a smoother, urethane-based flooring finished is desired. Additionally, Durex® Uraflex 150SC is used as a protective wall coating.
- Industrial floor coating
- Healthcare and Hospitals
- Food processing and pharmaceutical plants
- Protective Wall Coating
| Colour | Pigmented | |
| Mix Ratio | Part A (Resin):Part B (Urethane) | |
| Cure Time @ 23°C (75°F) | To touch: 6 hours | |
| Coverage | 4 m2/L (160 ft2/US gal) @ 10 mils | |
| Recommended Film Thickness | 5 mils (75 microns) min to 20 mils (500 microns) max | |
| Pot Life Working Time @ 23°C (75°F) | 20 minutes | |
| Reducer/Clean-up | Lacquer thinner or IPA | |
| V.O.C. | Zero |
| Method | Results | |
|---|---|---|
| Percent Solids | ASTM D7232-06 | 100% |
| Viscosity (Brookfield) 23°C (75°F) | ASTM D2196 | 2,500 cps |
| Abrasion Resistance | ASTM 5178-91, CS-17 wheel | 30 mg loss @ 1000 g load, 1000 cycles |
| Tensile Strength | ASTM D412 | 1,600 psi |
| Specific Gravity | ASTM D333 | 1.1-1.2 g/L (8.9-10 lb/gal) |
| Elongation | ASTM D412 | 100% |
| Low Temperature Flexibility | 1/8” Mandrel Bend @ -26C | Pass |
| Tear Strength | ASTM D624 Die C | 150 lb./In. inch |
| Adhesion to Concrete | ASTM C794 | > 350 psi (2.4 MPa): Concrete Fails |
| Shore Hardness A | ASTM C661-83 | 90 |
| Water Swelling | 6 hours | 0.05 (max % weight gain) |
| Water Vapour Transmission | ASTM E96 – Procedure B |
|
| Water Vapour Permeability | ASTM E96 |
|
| Water Vapour Permeance | ASTM E96 |
|
